I absolutely adore my NCase M2 and it's a gorgeous case, but the tiny round standard feet were an immediate red flag for me and my poor GPU. Especially because I planned to use the classic layout configuration for my PC. Inspired by the feet of the original NCase M1 I designed these feet, so my GPU won't choke.
The feet have a height of ca. 16mm and give my deshrouded GPU breathing room to take in enough fresh air to run happy and chilly without looking ridiculously tall. To insure the longevity of the feet I melted short M3 heatinserts into the feet. That way you can simply replace the standard feet with with these and reuse the screw without any problems.
Additionally four silicon bumpers come with the feet to make them more grippy.
For easiest installation: - remove the bottom panel of the pc case
++The listing is only for 4 replacement feet for the Ncase M2++
If you have any questions or requests, don't hesitate to message me! All pieces (except for the heatinserts) are 3D printed, so the print lines and texture are visible due to the nature of 3D printing. The prints will be cleaned before assembly and shipping. Surface finish and material may differ from the shown pictures, due to the use of different printers/filament.
